HVAC System supplier in UAE

Packless vibration absorbers are designed for installation in the suction and discharge lines of air conditioning and refrigeration system to dampen the transmission of compressor-induced vibration through system piping.

Packless vibration absorbers are constructed of deep pitch corrugated tubing in stainless steel for increased flexibility and vibration absorption, covered with high tensile stainless steel wire braid for superior strength. The vibration absorbers have female copper end connections for making sweat connections to refrigerant piping.

Each absorber is pressure tested then carefully vacuum tested using a highly sensitive helium mass spectrometer leak detection device. Units are cleaned, dehydrated and sealed in plastic film after final inspection to maintain cleanliness and dryness prior to installation. These are available either in bulk or individually boxed.

Packless Vibration Absorbers are compatible with all HFC, HCFC and CFC refrigerants. The stainless steel models, VAFS-3 through VAFS-11, are electrically welded with no braze joints to achieve the higher working pressures set by today’s industry standards.

Packless vibration absorbers are recognized under the component programs of Underwriter’s Laboratories, Inc., c-UL-US, File #SA2575.

Packless model VAF vibration absorbers are designed for installation in the suction and discharge lines of air conditioning and refrigeration systems to dampen the transmission of compressor-induced vibration through system piping.

Packless VAF's are constructed of deep pitch corrugated tubing for increased flexibility and vibration absorption, covered by high tensile wire braid for superior strength. Tubing and braid are reinforced by ferrules at each end, and connected to female copper tube ends by high temperature braze alloys. The units are designed for making sweat connections to refrigerant piping. Eleven models are available to fit copper tubing sizes from 1/4 inch through 1-5/8 inches O.D.

Each VAF is pressure tested then carefully vacuum tested using a highly sensitive helium mass spectrometer leak detection device. Units are cleaned, dehydrated and sealed in plastic film after final inspection to maintain cleanliness and dryness prior to installation. VAF's are available either in bulk or individually boxed.

Packless VAF's are recognized under the component programs of Underwriter's Laboratories, Inc., (C-UL-US) for application on both suction and discharge lines.